Residential surveys

Buying a 1930s house: what a survey usually finds

Oliver Hamblin MRICS ·

Interwar semis and detached houses make up a huge share of the housing in Surrey and the South West London suburbs - Stoneleigh, Worcester Park, Ewell, Hersham, Addlestone, Woking, Sunbury and dozens of estates like them. They are popular for good reason: generous rooms, decent gardens, solid construction.

They are also now around ninety years old, and most have been extended, re-roofed, re-wired or opened up at least once. Here are the issues we find most often on a 1930s house, and what they mean for a buyer.

Cavity wall ties

Most 1930s houses were built with cavity walls - two skins of brick held together with metal ties. The early ties were iron or lightly galvanised steel, and after the best part of a century many have corroded. As they rust they expand, which can crack the mortar joints in a regular horizontal pattern, usually every few courses.

It is not a reason to walk away. Replacement ties can be fitted from outside without rebuilding the wall. But it is a cost to know about before exchange, and the signs are easy to miss if you are not looking for them.

Bay windows

The two-storey bay is the defining feature of the 1930s semi, and it is also the part that moves most. Bays were often built on shallower foundations than the main walls, and the lintels and frames carry more load than they look as though they should. Cracking where the bay meets the main wall, a bay that has dropped slightly, or a sagging lintel over the ground-floor window are all common.

Most bay movement is old and has stopped. Some is not, particularly on London clay near large trees. Telling the two apart is a large part of what a survey is for.

Roofs

Many 1930s roofs still carry their original clay tiles, or the concrete tiles that replaced them decades ago. Original tiles are often near the end of their life, and the nails holding them can fail ("nail fatigue") so that tiles start to slip. Older roofs usually have no underlay beneath the tiles, which matters more as the roof ages.

Inside the loft we look at the timbers, at whether purlins or struts have been cut to make room for a conversion or storage, and at how the roof has been re-covered - a heavier concrete tile laid on a structure built for clay can cause the roof to sag.

Chimneys and removed chimney breasts

Chimney stacks on 1930s houses commonly lean, have eroded mortar, or show signs of sulphate attack from years of flue gases. Just as common is a chimney breast removed downstairs to make more room, with the stack above left without proper support. That needs checking against building regulations approval, and occasionally needs steelwork put in.

Damp, floors and ventilation

Ground floors in this period are often suspended timber, ventilated by air bricks in the outside walls. Over the years paths and patios get raised, extensions get built over air bricks, and the void beneath the floor stops breathing. The result is damp and, in the worst cases, rot in the joists.

Damp-proof courses of the period were usually slate or bitumen. They often still work; the more common problem is that they have been bridged by raised ground, render taken down to ground level, or a later extension.

Render and pebbledash

Pebbledash and render were popular finishes, and many have since been painted or patched. Render that has come away from the wall behind ("hollow" render) lets water in and holds it there. It is not always visible from the ground, and a tap test on a survey often finds more than the buyer expects.

Extensions, conversions and alterations

Very few 1930s houses are still as built. Rear extensions, loft conversions, garage conversions and knocked-through ground floors are the norm. The questions are whether the work was done properly, whether it had the approvals it needed, and whether it has affected the original structure - a knocked-through wall without adequate support is one of the more expensive surprises we find.

Asbestos and services

Asbestos was used in plenty of 1930s and later alterations: garage roofs, soffits, textured ceilings, old flue pipes and floor tiles among them. It is usually safe left alone, but it affects the cost of future work.

Wiring and heating will almost always have been replaced at least once. A survey will note what it can see; if the electrics look dated, a specialist test before exchange is sensible.

Which survey for a 1930s house?

A largely original, well-maintained 1930s house in reasonable condition can suit a Level 2 Home Survey. Once a house has been extended, converted, opened up internally, or shows signs of movement or damp, a Level 3 Building Survey is the better choice, because it explains the cause of each defect and what is likely to be involved in putting it right.

If you are unsure, send us the listing. We will tell you which level fits the house, and give you a fixed fee the same working day.

Oliver Hamblin MRICS

Chartered Surveyor with more than fifteen years' experience of residential and commercial property across Surrey, Berkshire, Hampshire and South West London. RICS-regulated firm no. 897221.

Not sure whether your assessment is right?

Send us the rates bill or just the property address. We will look at the published assessment and tell you honestly whether there is a case worth pursuing. There is no charge for that first view.

Request a free rates review

This article is general information about how business rates work in England, written for ratepayers. It is not advice on any particular property, and the rules change. If a decision turns on it, take advice on the facts of your own case.

Next step

Speak to a Chartered Surveyor about your property.

A short, no-obligation conversation is usually enough for us to recommend the right level of report and provide a fixed-fee quote.